*For use by Healthcare Professionals ONLY*
|
Meshers and V-Carriers
|
-
Information
-
Request Form
<
>
MESHER
The Humeca mesher is provided with a unique spring mechanism that prevents the blades from excessive pressure on the carrier during cutting, thus increasing the life time of the blades. The mesher can be adjusted in two positions: one to fit V10- or Zimmer® carriers and one to fit V15- or Aesculap® / B.Braun® carriers. During cutting, the carrier is guided both at the left and the right side to assure straight movement and exact connection of the grooves of a second carrier if applied.
Unlike most conventional meshers, where the carrier is moved through the device by means of intermittently pulling a ratchet, the Humeca® mesher is driven by the continuous rotation of a handle. The rotation makes the meshing procedure less time consuming and the design is far more ergonomic. Opening the bridge of the mesher allows easy access to the cutting axis for cleaning and inspection.
Unlike most conventional meshers, where the carrier is moved through the device by means of intermittently pulling a ratchet, the Humeca® mesher is driven by the continuous rotation of a handle. The rotation makes the meshing procedure less time consuming and the design is far more ergonomic. Opening the bridge of the mesher allows easy access to the cutting axis for cleaning and inspection.
V-Carriers
Humeca introduces a range of grooved skin graft carriers, called ‘V-carriers’. The symmetric V-shaped groove pattern of these carriers prevents unwanted sideward movement during cutting. The standard length of these carriers is 28 cm and thus longer than the length of existing carriers and care has been taken to ensure that the groove pattern of the carriers connect to each other. This enables cutting of extra-long graft strips. The V-carriers are available in versions that are compatible with Zimmer® meshers and versions that are compatible with Aesculap® / B.Braun® meshers. Of course both versions are suitable for use in the Humeca mesher. Available expansion ratios: 1:1, 1:1.5, 1:2, 1:3 and 1:6. The 1:1 carrier only perforates the graft without the intention of expanding it. This is to achieve sufficient drainage in full sheet grafts with hardly any graft pattern in the final result. This development work was supported by the Dutch Burns Research Institute and the Euro Skin Bank in Beverwijk, The Netherlands. The 1:1 perforation V-carrier was developed and clinically tested in close co-operation with the University Hospital Gent, Belgium.
For more information, click here for manufacturer product page.
Manufactured by Humeca BV, Netherlands
Manufactured by Humeca BV, Netherlands